boat outboard motor position
Sometimes when your boat is under hard acceleration , it will roll to the side, check whether the outboard is fitted too low/deep on the transom, a simple check of the correct outboard position. In some cases boat performance can be improved by mounting the outboard at a higher-than-standard position – with the anti-ventilation plate above the boat bottom. a higher mounting position will reduce lower unit drag and improve top-end speed, although because drag increases exponentially as speed increases, the benefit of reducing drag is. Engine. gear positions forward-neutral-reverse. gear ratio 2.15(28/13) trim and tilt system: manual tilt. drive unit. recommended fuel regular unleaded gasoline. integral fuel tank capacity 2.5l. recommended engine oil 2-stroke outboard motor oil. engine oil type genuine or recommended 2str engine oil. 
boat outboard motor position If you have your boat shrink-wrapped, ask them to either work around the motor, or leave gaps around the transom so some air can get to the motor. don’t start the motor out of the water winterizing action at spellman’s marina in oshkosh, wi, where more than 50 boats were waiting to be laid up.. According to marinepartsman.com, the outboard can be raised 1 inch above the standard height for every 10 miles per hour of speed the boat can attain. however, the motor should not be raised more than 5 inches above the standard position. raising the motor increases the speed of the boat while decreasing the effort needed to turn the boat..
No comments:
Post a Comment